dma radius manager mikrotik configuration

MIKROTIK:-PPPoE connecting over VPN(PPTP).

MIKROTIK:-How to add Secondary IP in Mikroitk inte.

MIKROTIK:-Hotspot Configuration On VLAN.

MIKROTIK:-Hotspot Configuration On Bridge Interface.

MIKROTIK:-Hotspot Bypass For specific Source IP in.

MIKROTIK:-Hotspot Bypass For specific Destination.

MIKROTIK:-Hotspot firewall rules for DNS Attack.

MIKROTIK:-HOTSPOT user login without Radius.

MIKROTIK:-Queue(QOS) All about in Mikroitk.

MIKROTIK:-Manually Created queue added in PRTG for.

CENTOS:-How to give the IP address in CENT OS minimal.

All ISP Networking Technologies(L.D Barik): MIKROT.

Redhat- Password Protection to the users.

MIKROTIK:-How To filter and block The Facebook In.

MIKROTIK:-How To give high bandwidth to your video.

MikroTik:How to find Mail spammer in your network.

MIKROTIK:-2 ISP link load balancing through defaul.

In my case I have configured the IP pool in nas the name of default and that IP pool i have configured in the Remote IP Address.

And you have to assign that Pool name in remote ip address. If you want enable the ip pooling in NAs then you have to create one IP pool in NAS and Radius as well but the IP will be provided to the users by NAS. But here I have enabled the IP pooling in NAS so I have disabled the IP pooling in Radius. NOTE:- The ip pooling is depend on your requirement because if you are using the radius server then you can enable the IP pooling in NAS and RAdius as welll but you cant enable the IP pooling in both nas and radius so you have to enable the IP pooling from one it can be your NAS or it can be your radius. Remote IP address:- The remote IP address means the users will get the IP address when they will dial using their username and password. Local Address :- The Local Address means, this local address will be the gateway of your PPPoE users and for recommendation it would be your WAN IP but also you can give your LAN ip. In my case I have selected the Profile1 as profile of my PPPoE server. The services will be available to the users. This is very important to configure the PPPoE profile for PPPoE users because based on your profile

If a host tries to establish a new session, the old one will be closed. One session Per host:-Allow only one session per host (determined by MAC address). The optimal value is the MTU of the interface the tunnel is working over reduced by 20 (so, for 1500-byte Ethernet link, set the MTU to 1480 to avoid fragmentation of packets.The recommenced MTU 1492 because there is adding some extra 8 bit ine header. And all your PPPoE users will be connected from that interface only. Interface :- which interface you want to run the PPPoE services you have select that same interface in the interface list. Service Name:Which ever the service name you can give according to you but sometimes you can create a problem like that when the users are setting their dial up connection they have to enter this exact service name in their device.

Dma radius manager mikrotik configuration